Ender 3 v2 15x15 UBL configuration files

[Riley-N]

Hello I was wondering if anyone has or knows where to get the config files for the 15x15 UBL. I wanted to modify my firmware to higher temps and only saw the 10x10 config files available. Thanks!

[Cal-LF]

@Riley-N The config files would start with the 10x10 ubl and make needed changes then compile.

[Riley-N]

Okay this is what I thought I would have to do. So would I only have to change the GRID_MAX_POINTS_X from 10 to 15? There doesn't seem to be a value for the GRID_MAX_POINTS_Y just below it. Or is that value somewhere else? Sorry I am new to compiling and just downloaded VS Code yesterday. Thanks

[Cal-LF]

@Riley-N The line below states the Y value will be the same as X.