Map Homekit "Stopping" state (Active=0 and InUse=1) on Finished and Cancelled

[QuickSander]

Currently the mapping is as follows:

Miele State	HomeKit InUse	HomeKit Active	Displayed in Home
Off = 1	0	0	Off
ProgramSelected = 3	0	1	Starting
WaitingToStart = 4	0	1	Starting
InUse = 5	1	1	Running
Finished = 7	0	1	Starting
Cancelled = 9	0	1	Starting

Finished / Cancelled could be mapped as follows instead:

Miele State	HomeKit InUse	HomeKit Active	Displayed in Home
Off = 1	0	0	Off
ProgramSelected = 3	0	1	Starting
WaitingToStart = 4	0	1	Starting
InUse = 5	1	1	Running
Finished = 7	1	0	Stopping
Cancelled = 9	1	0	Stopping

@MichelRabozee Would this be an improvement, or would it break your automation possibilities?

[MichelRabozee]

Hi, no problem with my automation (in Eve, you can act both on inUse and active), and yes, having it like the new mapping should be an improvement.
BTW, you seemed a while ago to say that it was not allowed to have inUse=1 with active=0 when I mentioned the Pause status (#1 (comment)).

[QuickSander]

you seemed a while ago to say that it was not allowed to have inUse=1 with active=0 when I mentioned the Pause status

True. Apparently based on a wrong experience. I was triggered by the later bug you discovered with the inuse/active logic that showed "arrêt" for you. Intuitively for me it is still a strange interface, but I have to get used to it.

[QuickSander]

I recall what I had in mind when writing it was: when active=0 HomeKit does not show the remaining time. Indirectly related to this new feature, but doesn't prevent this feature.

[MichelRabozee]

OK, I understand, and it is logically no issue for the state "stopping" to not display remaining time.