Using pin 7 for led #67
Replies: 7 comments
-
|
I saw this done somewhere. You don't need any code to make this happen from what I remember, the led should just turn on when connected. |
Beta Was this translation helpful? Give feedback.
-
|
It seems like the pin is disabled I tired it and no power I also tested
with a meter and nothing. I have checked Google and it seem that it hasn't
worked on klipper for anyone
…On Sat, Jun 17, 2023, 2:42 PM Bassam ***@***.***> wrote:
I saw this done somewhere. You don't need any code to make this happen
from what I remember, the led should just turn on when connected.
—
Reply to this email directly, view it on GitHub
<#67 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AAEJUVAGZM24UCUSF3KBPQDXLYCBXANCNFSM6AAAAAAZKKSEXQ>
.
You are receiving this because you authored the thread.Message ID:
<bassamanator/Sovol-SV06-firmware/repo-discussions/67/comments/6206186@
github.com>
|
Beta Was this translation helpful? Give feedback.
-
|
Had to run power to it it is disconnected in the control box |
Beta Was this translation helpful? Give feedback.
-
|
Nice. What are the steps to make this work? |
Beta Was this translation helpful? Give feedback.
-
|
There is a extra wire in the control box for the runout sensor cut the end
off and add it to the 24v fan connector on the power block. It's labeled
Def
…On Sat, Jun 24, 2023, 5:35 PM Bassam ***@***.***> wrote:
Nice.
What are the steps to make this work?
—
Reply to this email directly, view it on GitHub
<#67 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AAEJUVAML7WVL42LAWFR4ZDXM5TUFANCNFSM6AAAAAAZKKSEXQ>
.
You are receiving this because you authored the thread.Message ID:
<bassamanator/Sovol-SV06-firmware/repo-discussions/67/comments/6271101@
github.com>
|
Beta Was this translation helpful? Give feedback.
-
|
Ah of course. At some point I may include this on the everything sovol repo. Thanks! |
Beta Was this translation helpful? Give feedback.
-
|
I am going to buy you some coffee I thank you for your hard work and your
the man
…On Sat, Jun 24, 2023, 7:29 PM Bassam ***@***.***> wrote:
Ah of course. At some point I may include this on the everything sovol
repo. Thanks!
—
Reply to this email directly, view it on GitHub
<#67 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AAEJUVG364UDTQZFQG2C2Q3XM6A7JANCNFSM6AAAAAAZKKSEXQ>
.
You are receiving this because you authored the thread.Message ID:
<bassamanator/Sovol-SV06-firmware/repo-discussions/67/comments/6271403@
github.com>
|
Beta Was this translation helpful? Give feedback.
-
How do you add the code to use pin 7 for an led in klipper ? Can it be setup like the runout ?
Beta Was this translation helpful? Give feedback.
All reactions