Setup407_ST7789_320x170.h

// ST7789 170 x 320 display with no chip select line
#define USER_SETUP_ID 407

#define ST7789_DRIVER     // Configure all registers
//#define TFT_SDA_READ   // Display has a bidirectional SDA pin

#define TFT_WIDTH  170
#define TFT_HEIGHT 320

//#define CGRAM_OFFSET      // Library will add offsets required

//#define TFT_RGB_ORDER TFT_RGB  // Colour order Red-Green-Blue
//#define TFT_RGB_ORDER TFT_BGR  // Colour order Blue-Green-Red

#define TFT_INVERSION_ON
//#define TFT_INVERSION_OFF
#define TFT_BACKLIGHT_ON 1

#define TFT_BL     -1   // LED back-light  // 16
#define TFT_MISO   -1   // Not connected   // 19
#define TFT_MOSI   23
#define TFT_SCLK   18
#define TFT_CS      5 
#define TFT_DC     17
#define TFT_RST    -1   // Set TFT_RST to -1 if display RESET is connected to ESP32 board EN

#define LOAD_GLCD   // Font 1. Original Adafruit 8 pixel font needs ~1820 bytes in FLASH
#define LOAD_FONT2  // Font 2. Small 16 pixel high font, needs ~3534 bytes in FLASH, 96 characters
#define LOAD_FONT4  // Font 4. Medium 26 pixel high font, needs ~5848 bytes in FLASH, 96 characters
#define LOAD_FONT6  // Font 6. Large 48 pixel font, needs ~2666 bytes in FLASH, only characters 1234567890:-.apm
#define LOAD_FONT7  // Font 7. 7 segment 48 pixel font, needs ~2438 bytes in FLASH, only characters 1234567890:.
#define LOAD_FONT8  // Font 8. Large 75 pixel font needs ~3256 bytes in FLASH, only characters 1234567890:-.
//#define LOAD_FONT8N // Font 8. Alternative to Font 8 above, slightly narrower, so 3 digits fit a 160 pixel TFT
#define LOAD_GFXFF  // FreeFonts. Include access to the 48 Adafruit_GFX free fonts FF1 to FF48 and custom fonts

#define SMOOTH_FONT

//#define SPI_FREQUENCY  20000000 
//#define SPI_FREQUENCY  27000000
//#define SPI_FREQUENCY  40000000
#define SPI_FREQUENCY  80000000

//#define SPI_READ_FREQUENCY  20000000

//#define SPI_TOUCH_FREQUENCY  2500000

//#define SUPPORT_TRANSACTIONS