gopro_monitor_pole_mount

GoPro Mount for Pole-Shaped Monitor Stands

A GoPro mount for monitors with pole-shaped stands. The mount is offset to center the lens on the pole, and a little cable holder is included.

The GoPro frame used in pictures 1 and 2 is this one: https://www.printables.com/model/202221-gopro-hero-3-improved-top-and-bottom-frame-mounts

Print Settings

• printer: Prusa Mini+
• filament: Prusament PLA Orange
• print settings: 0.2mm with supports (lots of them 😢)

Customization

make.py creates STLs for mounting a GoPro Hero 3 on:

• an LG Ultrafine 27UP85NP [1]
• a Lenovo Thinkvision P27h-30 [2]

Beyond that:

• To make this design work for other monitor stands, adjust pole_d and pole_sheath_z in gopro_monitor_pole_mount.scad.
• The mount needs to be tall enough that the camera can peek over the monitor. By default, the GoPro mounting axle is located 3cm above the end of the pole (pole_offset_z = 30). For tall or vertically oriented monitors, larger values might be required.
• GoPros other than Hero 3 might require a different gopro_lens_offset to be horizontally centered.