How to Assign Different IP Addresses to Two LiDAR Sensors Connected via Ethernet?

[moonmoonmoonmoon]

I am using a host machine connected to two LiDAR sensors via two Ethernet cables. When I use the command ping xxx (where xxx is the serial number of the sensor), I discovered that both LiDAR sensors have the same IP address. As a result, I am unable to receive data properly. Is there a way to assign different IP addresses to these two sensors? Any guidance or suggestions would be greatly appreciated!

[matthew-lidar]

You can use this endpoint to set the static IP of the sensor: https://static.ouster.dev/sensor-docs/image_route1/image_route2/common_sections/API/http-api-v1.html#put-api-v1-system-network-ipv4-override

[moonmoonmoonmoon]

You can use this endpoint to set the static IP of the sensor: https://static.ouster.dev/sensor-docs/image_route1/image_route2/common_sections/API/http-api-v1.html#put-api-v1-system-network-ipv4-override

thank you!