Zybo z7

[mehr74]

I want to run RISC-V rocket-chip on Zynq FPGA Board (Zybo Z7), what are the constraints I have to add to the project?

[yuliu2015]

I'm also trying to run the rocket core on Zybo Z7 (part no: XC7Z010-1CLG400C) without success using the pre-built. Seems we need to re-build from scratch with the new Zybo Z7 board constrain file (provided by Digilent) in vivado.

[mehr74]

I tried to build from scratch as well but I could not be able to run any program on the FPGA. Please let me know if you did that.

[JeremieMelo]

I'm also trying to run the rocket core on Zybo Z7 (part no: XC7Z010-1CLG400C) without success using the pre-built. Seems we need to re-build from scratch with the new Zybo Z7 board constrain file (provided by Digilent) in vivado.

I am using zybo-z7-20, I can boot linux from ramdisk, but cannot use fesvr-zynq to communicate with rocket core. How about your project?

[gongqingfeng]

I'm also trying to run the rocket core on Zybo Z7 (part no: XC7Z010-1CLG400C) without success using the pre-built. Seems we need to re-build from scratch with the new Zybo Z7 board constrain file (provided by Digilent) in vivado.

I am using zybo-z7-20, I can boot linux from ramdisk, but cannot use fesvr-zynq to communicate with rocket core. How about your project?

I meet the same problem with you. I am using zybo and I can boot linux from Ramdisk. However, I can't run "./fesvr-zynq pk hello" successfully: I can't get any response from the command line, that is, arm cores can't communicate with rocket core.
Do you solve this problem? Thank you very much!