https://store.openipc.org/OpenIPC-AIO-Mario-v1-0-p633320808
Remove the lens cover film befor use
The Mario camera case with 4x M1.2 screws.
Side mount holes are M2 x2 screw thread.
Install atennas for AIO.
Red glimmering Power on with Battery
Red Wired linked
Blue flash RF transmitter
Green TBD
Board Size 30mmx32mm with 4*M2 mount holes.
Heat Sink with 20mmx20mm mount holes.
Power input:
2S-6S
The on board dualway BEC Capacity:
RF BEC on board is up to 3A 5V output
MSIC BEC on board is up to 2A 5V output
enter uboot use uart device connect to top of AIO board(R0,T0)pad.
Power on AIO with Battery connector(GH1.25* 6 pin), after the blue LED flashing, plug in usb cable and connect to PC
in windows:
go to control panel- internet -network:
find a usb2.0 to fast Ethernet Adapter
set this card ipv4 address to 192.168.1.11 mask:255.255.255.0
apply
then open ssh to connect AIO address:192.168.1.10
user:root password:12345
Update firmware possible via SD card or just use win scp drug the rootfs and kernel files to /tmp
sysupgrade -n -z --kernel=/tmp/uImage.ssc338q --rootfs=/tmp/rootfs.squashfs.ssc338q
You can download firmware via the link that is used for online updates.
Or just use the configurator - https://github.com/OpenIPC/configurator
RF antenna characteristics
Default Antenna is ANT1 for 1T1R, ANT0+ANT1 is 2T2R
Reconmand RF setting
RF Power max 18dbm for onbard PA. 0~-25dbm setting
MCS index 1,3(0-7 is 1T1R, 8+ is 2T2R)
stbc=1,ldpc=1
Video biterate:4096 /8192/12688(mcs 3+)
Keep RF poweroff or power=1 when on bench test(when only usb connect)
on bench test or debug is disable the record function defaultly
To enable the recording function set (record value)true in majestic.yaml
On board heat sink and cooling fan:
cooling fan out put power up to 500mA max
all heat sink mount holes are M2 screws thread.
USB only for debug mode
Power limited 5W input.