Duo-V1.0.5

Change log V1.0.5

• Added support for IPV6.
• Replaced cvi_pinmux command with duo-pinmux, more information here.
• Reordered the pin numbers in wiringX and python-pinong library.
• Released the generic freertos code for the second core (little one).

---

The firmware introduction:

• Enable ssh
• Enable RNDIS
• Blink LED
• Root password: milkv

Login via RNDIS using ssh:

ssh [email protected]

If you want to disable LED blinking:

mv /mnt/system/blink.sh /mnt/system/blink.sh_backup && sync

then reboot the board.

Use the IO-Board

Note that when using the IO-Board, the USB network (RNDIS) is not available, Please use the Ethernet interface on the IO-Board.

If you need to assign a fixed MAC address to the Ethernet port of the IO-Board, please execute the following command(Replace the MAC address in the command with the MAC address you want to set, and please note that MAC addresses of different devices within the same network segment must not be duplicated).

echo "pre-up ifconfig eth0 hw ether 78:01:B3:FC:E8:55" >> /etc/network/interfaces && sync

then reboot the board.

Enable the 4 USB ports on the IO-Board:

rm /mnt/system/usb.sh
ln -s /mnt/system/usb-host.sh /mnt/system/usb.sh
sync

then reboot the board.

Restore the USB network (RNDIS) when the IO-Board is not used:

rm /mnt/system/usb.sh
ln -s /mnt/system/usb-rndis.sh /mnt/system/usb.sh
sync

then reboot the board.