The firmware source repository: ZMK Configuration
A full write up about the configuration: Gigapad write up
| Part | Quantity Used |
|---|---|
| Seeed Studio XIAO nRF52840 | 1 |
| EC11 Rotary Encoder | 1 |
| Rotary Encoder Knob | 1 |
| Cherry MX Switches | 3 |
| Keycaps | 3 |
| Self tapping screws | 4 |
| Rubber feet | 4 |
The battery should be soldered to the pads on the bottom of the XIAO module BEFORE mounting it to the PCB. Once the module is soldered in place on the PCB, you will **not** be able to access the battery pads again. Be careful with bare battery leads!
